Power Automate: AI-assisted UI Automation repair
AI-assisted selector repair for Power Automate flows
Microsoft is developing an agentic debug run feature in the Power Automate flow designer to help users repair UI automation. General availability is targeted for March 2027.
Key points
- The repair interface launches while the flow is running.
- It validates each selector used in the flow.
- If a selector does not work as expected, it proposes a replacement after the user captures the relevant element for reference.
- The roadmap lists Web and Worldwide (Standard Multi-Tenant).
What to do
Tell flow builders that repair will propose replacement selectors after they capture the relevant UI element. Treat March 2027 as a general availability target, not a confirmed release. Verify availability before planning adoption; the listed July 2026 preview target does not confirm that preview access began.
Timeline
- July 2026 Preview (planned, not confirmed) Microsoft 365 Roadmap target: Roadmap preview target; availability is not confirmed.
- 27 October 2026 Published
- March 2027 General availability (planned) Microsoft 365 Roadmap target: Roadmap general availability target.
Speaker notes
This feature is intended to help flow builders debug UI automation in the flow designer. During a debug run, the repair interface validates selectors and proposes a replacement when one does not work as expected. The user must first capture the relevant element for reference, so this is not described as unattended repair. Microsoft still lists the feature as in development. The roadmap gives a July 2026 preview target and a March 2027 general availability target, but neither is evidence of a completed release. Licensing requirements and admin controls are not specified.
Sources and links
- Roadmap Microsoft 365 Roadmap 577869
Area, status, change type, licence and flags are indicative. Always open the source before you act on a card.